Frequently Asked Questions
Q) What is the weight of a Load-Lid™?
A) A standard Load-Lid™ weighs approximately 50-70kg.
Q) Can I open the Load-Lid™ with gear on top?
A) The Load-Lid™ is supplied with gas stays which are at the optimum pressure for everyday use and are designed to help you open and close the lid.
However, they won't hold the lid open with a load on top. This is because it would require up to 200kg's of upwards pressure to open the lid with a load on it meaning that the operator would need to pull down with 200kg's of force to close the lid again which is not physically possible.
If you are carrying a Roof Top Tent and require access to the Tub, we recommend removing the locking plate on the Load-Lid™ handle so you can access the Tub through the tailgate (see below).
Q) Can I open the tailgate when the Load-Lid™ is closed?
A) The Load-Lid™ comes standard with a locking plate under the handle which serves as an extra security measure. If required, you can remove it which will allow you to open the tailgate while the Load-Lid™ is closed. Depending on your lid model you may need to open the lid slightly to get the tailgate open.
If your Ute doesn't have a central locking tailgate we recommend that you install this to provide security without the plate.
Q) What if my Roof Top Tent and with people inside is over the 200kg rating?
A) The Utemaster Load-Lid™ has a dynamic load rating of 200kg, which means you can carry 200kg of gear when driving. The load rating requirement when driving is far greater than when the vehicle is parked.
When the vehicle is parked, the Load-Lid™ will support the weight of 2 people inside a Roof Top Tent.
Q) If I don't add the Central Locking accessory, can I still lock my Load-Lid?
A) Yes, the Load-Lid™ comes with a set of keys which allow you to lock the lid manually.
Q) Is the Load-Lid easy to fit?
A) The Standard and Sports Bar Load-Lids are very easy to install and are be done without needing to drill into the tub. We recommend you check out the instructions listed further up this page so you can see how it works for your model.
If you are not confident in doing this yourself we can arrange fitting through one of our resellers.
Q) Will the Load-Lid™ work with my liner?
A) If it is a spray-on liner you'll have no issues fitting the Load-Lid. If you have a plastic liner that goes over the top of the Tub you may need to cut it down so the lid sits correctly and does not leak.
Q) Will the Load-Lid™ work with my slide-out fridge?
A) The Load-Lid™ sits above the edge of the Tub, so the height of the fridges you can fit is determined by the Tub depth. It is very common for customers to put fridges underneath the Load-Lid.